The item of digital vibratory detector use the international advanced photoelectric sensor elements with CPU processing technology to ensure the rigorous monitoring for the protective coverage.
Adjustable detective sensitivity in order to balance point correctly. It is applicable to Automatic teller Machine(ATM) and wall, glass and strongbox etc. And preven any action of knock and destruction. (Hard wired)
Operating Voltage: 9 ~16V DC
Current: 11mA at 12Volts
Alarm Contracts: 0.1amps, 24 Volts. NC
Tamper contacts: 0.1amps, 24 Volts, NC
Alarm Time: 2.2s min
Warm time: <2 minutes
Operating Temperature: -20C to 50C
Storage Temperature: -20C to 60C
Mounting Fashion: Suface
Wire the cable to the terminal block at the bottom of the detector
12V DC : Power supply inputs
Alarm: N, C dry contacts
Tamper: N, C dry contacts
Adjust the sensitivity to the correct point.
Replace front cover
Apply power and wait until stabilized (>2minutes)
Do necessary test and observe LED, confirm sensitivity to the correct point
Tighten the holding screw to secure the PC board.
1. Open the cover (fig.1)
2. Retain the cover and loosen the screw (fig.2)
3. Remove the main front cover carefully and avoid dropping the crew.
Punch out Knockout at the bottom or the side of the detector (fig. 3) and remove knockout for cable entry.
4. Attach base to a correct position. And feed the cable into the detector (fig. 4)
Buyer should have the product properly installed and maintained alarm to reduce the risk of burglary, robbery, fire without warning.
Products sold are with original factory package and quality will be guaranteed for 6 months. In case of any defect found, seller will replace the product once problem confirmed. Buyer will charge the goods returning freight and seller charge the resending freight.
Thanks for viewing our store and our products. The seller is doing her most effort to meet woldwide customer's requirement. If you have any question, requirement, advice, please leave it to seller. That will be highly appreciated!