Specifications:

• This is a flexible strip of auto LED lamp
• This Car Strip Light is made of super bright LED
• The LED Car Light is slim and flexible and can be bent easily to fit the place you like without damage
• Waterproof for both exterior and interior use
• You can fix the Car Light Strip on the car underbody or any other place you like
• The flexible Car Light Strip is also perfefct for decorating your car
• Size: 90cm/35.43in (L)
• Color of the LED Lamp: Blue

Details:

• Flexible strip of auto LED lamp
• This LED Car Light is flexible and bendable and you can place it onto your car without damage

• This Car Light Strip is made with super bright LEDs. Perfect for decorating your car
• Flexible Car Light Strip uses high intensity LED, less heat output and extremely low power consumption

• This Car Light Strip suits for your car, truck, boat, motorcycle, ATV, or golf cart
• This Car Light Strip with special design also makes it very easy to install and use. It's low power consumption and also can make your car to get a charming fancy look

Car Flexible Light Strip Show:

How to Connect Motorcycle LED Lights:

• Locate areas under the motorcycle body or fairing where you would like to install the LED lights. Ensure that there are no hot motorcycle parts close to the locations you pick
• Clean the areas where you will be installing the lights with alcohol prep pads. This removes the dirt and grime. Allow the alcohol to dry thoroughly so the LEDs will have a clean, dry surface to attach to
• Remove the adhesive backings on the LEDs and install them by pressing them firmly against the motorcycle surface. Most LED light strips are flexible and can be curved around the fairing for better illumination
• Remove the seat and run the wires through the frame of the body to underneath the seat where the battery is located. The wires should not be visible on the outside of the bike
• Collect all the wires and tighten them together with a wire tie. This keeps the wires organized
• Loosen the terminal bolts on the motorcycle battery by using your screwdriver. Tighten the terminal bolts back into place so they firmly hold the wires down
• Start your motorcycle and watch your LEDs light up. If all or some of the LEDs are not operating properly, check the battery terminal connections first to ensure that they are tight. If the problem is not resolved, check the clamp connector wiring to ensure that all the wires are stripped properly and in full contact with the inside of the connector

 

Package Included:

• 1 x Car Decorative LED Light