Specifications:

• 1500mAh high capacity for long time use    
• High performance li-ion battery
• Lightweight and easy to install
• Capacity: 1500mah
• Voltage: 11.1V
• Continuous Discharge Rate: 15C
• Charging Time: About 2 hours (by input 1A)
• Compatible with: RC helicopters
• Size: 70 x 33 x 25mm/2.8 x 1.3 x 1.0in (L x W x H)

Details:

• Measuring only about four inches long, this mini RC Rechargeable Battery is a fascinating Rechargeable RC Battery that is very stable and easy to make the RC models fly in the spaces

• This is a MYSTERY 11.1V 1500mAh 15C Lithium Polymer Rechargeable Battery, stable circuit protection no need to worry your device running out power on the go

• Remote Control Helicopter Battery has maximum charge rate and 15C continuous discharge rate, lithium polymer 1500mAh battery pack, 1500mAh high capacity for long time use

How to Install a Battery in an RC Helicopter

The weight of your remote-control helicopter is an important factor if you're planning to install a battery in your helicopter. Many RC enthusiasts choose a lithium polymer battery as their optimal RC battery. A lithium polymer battery produces treble the energy you get from a nickel battery and lasts longer between charges. Installing a battery in your helicopter is generally a relatively straightforward procedure, as the wired connections just plug together.

• Open the battery-access panel near the front of your RC helicopter. Position your battery into the small battery compartment, making sure the wires from the battery are easily accessible.
• Use a few strips of clear adhesive tape to hold the battery in place. This keeps it from moving around during a flight.
• Locate the electronic speed controller. It is usually centrally placed and effectively connects the motor, receiver, switch and battery together. There are two loose wires extending from the ESC with a dual connector on the end; the other wires from the ESC are connected to the other equipment.
• Insert the red wire from the battery into the terminal connector from the ESC that has the red wire attached. Insert the black wire from the battery to the terminal connector from the ESC that has a black wire connected. Simply push the wires into the connector using your fingers. Close the battery-access panel on your helicopter.

Caution:

• Must read charging instructions before use
• Do not charge battery unattended
• Use specified charger only
• May explode if damaged or disposed of in fire
• Do not short-circut

Package Included:

• 1 x Lithium Polymer Rechargeable Battery