Specifications:

• Metal housing mount is ideal for CCD CCTV camera
• All parts interchangeable
• Easy to install, sturdy design
• Three bolt holes on the base
• Easy adjusting CCTV camera mounting bracket
• The camera mounting bracket is the perfect assistant for the security camera
• Meterial: Aluminium alloy
• Type: Indoor, outdoor, wall and ceilling
• Dimension: 5.9 x 3.5in

Details:

• What you are viewing is the powerful and high-strength camera bracket

• This CCTV camera mounting bracket is made of the finest aluminum alloy material

• Round edge designed camera bracket will not scratch your camera and yourself while you are installing the CCTV security camera

• And the horizontal angle of this CCTV camera mounting bracket can freely adjust to any direction you want

• With three bolt holes on the base of the camera bracket makes the installation easier and convenience

Instructions for Mounting a Sturdy Bracket:

• A shelf held up by brackets.rack and shelf image by Lars Christensen from Fotolia.comMounting a bracket to a wall requires you to attach the bracket with screws into a secure wall stud. Just screwing a bracket into a stud is not enough to make it sturdy. It also must be level, with screws far enough into the studs that it will hold firmly

Instructions:

• Run a stud sensor over the wall where the brackets need installation. Choose the proper height for the bracket and make a mark on the wall with a pencil to indicate the location of the stud and the bracket's height
• Position the bracket on the wall so it is over the marked stud. Hold the bracket in place with one hand and use a level to get it straight. Without allowing it to shift on the wall, make pencil marks through the bracket's mounting holes to note their locations on the wall
• Drill pilot holes into the wall and the stud at the locations of the pencil marks. Use a drill bit smaller than the screw to ensure that it bites into the wood securely. Use at least 2-inch long screws to ensure that the bracket will be securely attached to the stud
• Break two flat wooden toothpicks in half and slip them into the holes. The toothpicks make the bond between screw and hole tighter and add to the overall strength of the bracket
• Place the bracket over the holes and insert screws into each hole. Tighten each screw two-thirds of the way into the wall using a hand held screwdriver. Hold a level against the bracket and tighten the top screw securely. Tighten the bottom screw completely, but make sure that the bracket remains level

Package Included:

• 1 x CCTV Camera Mounting Bracket