|
This greatest guard protector for LCD screen of your APPLE IPHONE 1st GENERATION! Clear and functional! Against scratching, scraping and abrasion, removable without leaving residuary mark. resistance to erosion and finger-print! Good choice for your phone!
Description:
- New generic Reusable Screen Protector: IPHONE 1st GEN Screen Guard
- NOTE: Please do not perform installation in a dusty environment. Please read installation steps from the two tabs on the front and back protector layers before performing installation.
- Protect your cell phone's LCD screen against dust and scratches and eliminate glare
- Designed for perfect fit with the LCD screen
- IPHONE 1st GEN LCD Film offers tough, durable, transparent surface while keeping the LCD screen clean and unscratched
- Attaches smoothly with self-adhering surface; leaves no residue when removed
Features:
- 99% UV Protection: Reduces eye strain caused by the LCD screen
- Anti-Scratch Film: thickest and most durable
- 99% Transparent: unmatched clarity
- Washable and Reusable: Never need to buy another screen protector again
- No glue residue when removed
- Ultra Smooth Surface: Enhance the experience and utilization of touch screen and stylus features
Item Contents:
ULTRA CLEAR Screen Protector for iPHone 1st GENERATION x 3 (NOT FOR 3G IPHONE)
Don't know how to apply screen protectors on your cellphones ?
 |
Step 1 Clean the screen surface thoroughly, ensuring that there are no dust dirt particles or fingerprints that may cause bubbles. |
 |
Step 2 Remove a portion of the protective mask labeled step 1. align the clinging surface with the edge of the screen. |
 |
Step 3 Slowly peel off the rest of the mask and allow the protector to cling to the screen, while gently pressing out the air at the same time. |
 |
Step 4 Remove the final protective mask labeled step 2. once removed you will see a glass like finish which look identical to the original screen. |
 |
Step 5 Removal process expertshield screen protectors can be easily removed using the following methods: Using a piece of strong adhesive to lift one of the corners. |
 |
Step 6 By sliding a thin piece of plastic polymer between the pet and the device (remember that there is only an air vacuum and no adhesive, thus there always a micro gap between the pet and the surface). |

|